The Cabbone is a guitar amp speaker cabinet switcher that enables the user to toggle between two cabinets using one head. To ensure safety with both solid state and tube amplifiers, switching is performed using a series of high-power relays that are microprocessor controlled in a delayed fashion with a slight overlap. The audio circuit is essentially a solid copper wire which will have no effect in terms of distortion or artifact. And although the Cabbone is rated at 100 watts RMS, short term peak power transients will not harm it. This power limit is base do the power handling capacity of the relays. Should greater power handling be required, larger relays may be special ordered to enable 300 watt RMS amps to be used.

Trimode Block Diagram
Specifications are subject to change without notice.
Circuit type: Microprocessor control relays
Max amplifier power to input: Cabbone - 100 Watts RMS
Cabbone EX - 300 Watts RMS
Switching type: Programmed PIC controlled mechanical relays
Relay type and capacity: Silver plated contacts - 10 million cycles
Cabbone - 100 Watt rated
Cabbone EX - 300 Watt rated
Switching time: 11.2 milliseconds
Outputs: Speaker-1, Speaker-2 / Alt-Z Speaker-2
Slingshot™ implimentation: Slingshot input Slingshot out/thru - latch or pulse (selectable)
Footswitch: High-cycle heavy-duty Speaker-1/Speaker-2 toggle w/ status LED's
LED indicators: Large 3mm OD ultra-bright LED's
Construction: 14 gauge steel, baked enamel finish
Size: 6.85 x 4.5 x 2.12" (175 x 108 x 54mm)
Weight: 2.2lb (
Production: Made in Canada
Power supply:
15VDC 400mA, center pole positive

Part # R800 9407 00 - 120volt
Part # R800 9407 01 - 230volt
Part # R800 9407 02 - 230volt
Part # R800 9407 03 - 100volt
Part # R800 9407 04 - 240volt

USA, Canada, Taiwan
Continental Europe
United Kingdom