PLEXITUBE SPECIFICATIONS

Built like a tank and designed to fit on most pedalboards, the Tonebone Plexitube is tremendously powerful. It is in fact a hybrid that combines the control of a triple-stage solid-state front end with the warmth and natural even harmonics generated by a 12AX7 tube. The tube is mounted on its side to lower the pedal profile for easy foot pedal action. This is powered by a high output 15 volt - 400 milliamp supply to deliver more than twice the power of a typical 9V PSU. Power is internally regulated and filtered to eliminate noise.

To deliver maximum tone, full-size discrete parts are employed throughout. These are hand inserted and then soldered to a double-sided circuit board with a full-surface ground plane making the Tonebone Plexitube one of the quietest pedals in its class. High lifecycle footswitches combine with steel shafted potentiometers for maximum durability. The outer case is made from heavy duty 14 gauge steel to eliminate stress on the circuit board which helps prevent premature part failure. The Plexitube is then finished in a durable baked enamel finish.

The Plexitube is made with pride in Canada.

Trimode Block Diagram

Click images to view larger

Specifications  
Specifications are subject to change without notice.
Circuit type: Hybrid tube / proprietary circuit
Tube type: Standard 12AX7 vacuum tube
Input impedance: 1meg Ohm at input jack
Output impendence: 10K Ohm
Drive: Input drive gain control for both channels.
Intermediate ch-2 drive trim adjuster Recessed control - accesable with a tweeker.
Voicing 1 & 2:
Used inconjunction with the Ch-1 and Ch-2 Contour controls

CHANNEL-1
Fat
Scoop
Out

CHANNEL-2
Fat
Scoop
Extra Scoop
Ch-1 & Ch-2 contour Separate sound shaping control for each channel. Used in conjuction with the VOICING 3-position switch
Mid Boost:
Used to fatten up the sound for more cut and sustain during solos. Also, will fatten up the sound of single coil pickups.

High:
Medium:
Off:

+12dB @ 620Hz
+7dB @ 390Hz
No boost
Top End:
Switch sets the overall tonal character of the Plexitube to best match the amp and settings. Brighter amps are normally compensated with darker settings.

Bright:
Flat:
Dark:

Boosts +6dB @ 10kHz
No boost or cut
Cuts -6dB @ 1.8kHz
High & Low EQ:

Low:
Hight:

+/- 14.5 db @ 100Hz
+/- 10 db @ 4.3kHz
Footswitches: True bypass with green on/off status LED
Heavy-duty high-cycle switch
LED indicators: Large 3mm OD ultra-bright LEDs
Construction 14 gauge steel, baked enamel finish
Size 8.12 x 4.25 x 2.12" (207 x 108 x 54mm)
Weight:
2.15lb (1kg)
Power Supply:
15VDC 400mA, center pole positive

Part # R800 9407 00 - 120 volt
Part # R800 9407 01 - 230 volt
 Part # R800 9407 02 - 230 volt
Part # R800 9407 03 - 100 volt
Part # R800 9407 04 - 240 volt

USA, Canada, Taiwan
Continental Europe
United Kingdom
Japan
Australia