Click to View Manual

Texas-Pro™ USING & APPLICATIONS

The Texas-Pro is an exciting new pedal that combines a power booster with a versatile overdrive, giving you a wide range of tonal possibilities while saving space on your pedalboard. The overdrive section lets you set the amount of drive and the output level to your amplifier, along with a tone control for dialing in your sound. Next, the Boost section provides huge amounts of gain when you need it, activating an effects loop at the same time to add pedals into the chain when soloing. For complete details on the Texas-Pro, please click on the icon to the left to download the manual.

Making Connections

Before you connect to the Texas-Pro, make sure to turn your guitar amp down or off to avoid loud turn-on transients that can cause damage to your amplifier. There is no power switch on the Texas-Pro, you simply connect to a 9V supply and the unit will turn on. You can check that it is receiving power by depressing one of the footswitches to see if the LED illuminates. The Texas-Pro does not come with a power supply as most players will use a multi-pedal power brick on their pedalboard. You can use a standard Boss® style 9V adapter for power, with a 2.1mm barrel connector wired for center-pin negative polarity. The power cable can be affixed to the pedal using the cable lock provided, preventing accidental disconnection. Use a hex key to unscrew the cable lock, pass the cable through the cavity, and then retighten.


The Overdrive

Start with the LEVEL and TONE controls at 12 o’clock, and the DRIVE control set to 9 o'clock. Next, turn your amp on and the volume up, and depress the DRIVE footswitch. Test out different settings on the LEVEL control to get an idea of the range of the overdrive, as it can provide a lot of gain to your signal. Now you can experiment with the TONE and DRIVE settings. The TONE control will add more high frequency content as you turn it clockwise. All three of these controls interact, so increasing the DRIVE will also increase the overall output level.

The Range

The 3-position RANGE switch has three settings: Vintage, Modern, and Maximum. Each of these options will provide a different flavor of overdrive, from a bluesy vintage style, to a beefier modern tone, or a maxed-out aggressive voicing with plenty of saturation. Try each setting out while also changing the TONE control to explore the limitless possibilities for your tone.

Close-up of range switch

The Booster

Start with the BOOST level down at 7 o'clock. Turn off the overdrive, engage the BOOST footswitch, and listen as you increase the volume. You can use the BOOST function for high-output soloing, or to push the front end of your amp harder. When the BOOST is activated, it will also engage the effects loop, bringing your effects pedals into the signal chain after the overdrive section and before the BOOST.

The Effects Loop

The built-in effects loop allows you to connect a series of pedals that are brought into the signal chain when you engage the BOOST footswitch. This allows you to simultaneously activate the Booster and a delay or chorus pedal, giving you a more streamlined and professional transition for soloing. The effects loop employs standard ¼" guitar cable connections.

You can also use the effects loop in other creative ways:

Connecting a tuner

You can connect a tuner to the effects SEND jack and when the BOOST is engaged, it will shut off the signal going to the amp for quiet on-stage tuning.

Connecting a second amp

You can also connect a second guitar amp using the effects send; however, as this output is not isolated, you may experience a ground loop. To minimize the possibility of noise, make sure both amps are connected to the same electrical circuit using a power bar. Also make sure both amps have a proper U-ground attached for safety.

Connecting a second guitar

You can connect a second guitar to the Texas-Pro by using the effects RETURN jack. This will bypass the overdrive circuit and feed directly into the Booster when activated.